L63-8 – Angle Base Flange

Similar to a Type L62, but used to set up the upright at an angle between 45° to 60°. This fitting should only be subjected to light loads which cannot be positioned at 90° to the applied loads. For greater loads or other tube sizes, a type L62 flange is used and the upright bent to the required angle. Ø indicates the diameter of the fixing hole.

£30.99

Similar to a Type L62, L63-8 is to be used to set up the upright at an angle between 45° to 60°. This fitting should only be subjected to light loads which cannot be positioned at 90° to the applied loads. For greater loads or other tube sizes, a type L62 flange is used and the upright bent to the required angle. Ø indicates the diameter of the fixing hole.