The Type BT clamp is specifically designed to clampto the tapered flanges of Structural I-Beams and steelchannels. The clamp has a recessed upper surface that is designed to hold the head of a bolt in place while the nut is tightened. The rear section of the clamp is called the tail and is available in two different tail lengths, these being size 1 and size 2 [see Dimension E on the table below]. By selecting the appropriate tail length and with the use of BeamClamp shims any thickness of steel flange can biconnected To make selecting the correct tail length easier please refer to Table 2 and 3 on page 17 of the catalogue.
- Manufactured from high strength ductile iron
- Hot Dip Galvanized for corrosion protection
- All loads guaranteed with 5:1 Factor of Safety
Please us the following resources to help you configure BeamClamp